A few kms down the road i got the bing bong suspension normal height only as i was in that mode. Got to where i was going had a look but could not find where it was coming from. The next day was driving through tracks all day when at the end of the day bing bong suspension fault at the raised level. Hi all, I've been a Land Rover owner for about 4 months now (2006 LR3 55000 miles) and absolutley love the truck. Its a dd for the wife and I only get the chance to drive it a few times a month. Every now and then we get a suspension fault and once we've gotten an HDC fault but everything appears to work fine. 26 posts · Joined 2022. #6 · Jan 16, 2023. No, it doesn't work at all. I recently had the front strut assemblies replaced, because there was a leak and I thought that would solve it. However, it did not. Now I can't raise or lower the car without it going into the normal height-only mode or suspension fault. This is inconvenient because my Additionally, the fix is not suspension system related, but in this case steering system related, ie, a wheel alignment. When the system drops due to a wheel height sensor fault, the system is still doing what it is supposed to do, that is protect LR from a potential liability claim, however the fix will be suspension system related. Hi All, Have had a fault recently come up on the dash 'only normal height available'. I have owned the 2010 disco for about 6 months and fault has just showed, it doesnt seem to drop obviously overnight and suspension appears okay when driving, previous owner had installed a new Aerosus compressor just before I purchased the vehicle and on Suspension Fault , Compressor not running Hello everyone I’ve read a lot of posts that had to do with suspension faults, and they were helpful. However a couple of quirky things happened with my rover with timing of this failure that I wanted to start a thread to pick your brains. All help is much appreciated I have 2005 LR3 with 197k miles. In the last few thousand miles its been throwing up a 'suspension fault' message either at start up or during the journey. It will say stay below 30 if i drop below that speed and increase again. The suspension doesn't drop, or seem to when left. So to sum up After 5 miles or so, I got the amber "suspension warning" light and had these codes: C112F-72 (68) (GAP tool: "Air spring valve - Mechanical failure - actuator is stuck open") and. C1130-66 (68) (GAP tool: "Air spring air supply - Algorithm based failure - signal has too many transitions/events"). No performance issues so I carried on. Suspension Fault "Normal Height Only". Fault started occurring when driving with a a 12' enclosed trailer through Cincinnati. At the time I attributed it the the horrendously bumpy roads, and the air compressor having to constantly compensate for the trailer weight changing from the bumpiness of the roads. After a ignition reset, problem went tel.: +421905448329. auto: D90 td5,/D2-3/D4,D5. Bydliště: skalica. Kontaktovat uživatele: Re: Disco 3 - Suspension fault. #43 od erik » 28 říj 2010 09:12. RudaK píše: Jan Kucera píše: dost se divim, že ten celej štymulovehemnt ještě nedostal šutrem a šel do věčnejch lovišť.. Takovéjch věcí tam je víc oni angláni goUNREm.